Re: SOLAR HOT WATER DIY USING BLACK WATER HOSE PART 1
Sep 10th, 2008 by Mr.Burton
Solar Pool Heater… and FYI for the DIY
Duration : 0:6:0
5 Responses to “Re: SOLAR HOT WATER DIY USING BLACK WATER HOSE PART 1”
Reduce The Cost Of Solar
-
Categories
Learn More Pay Less
Sep 10th, 2008 by Mr.Burton
Solar Pool Heater… and FYI for the DIY
Duration : 0:6:0
I tried a waste oil …
I tried a waste oil burner with copper coil but it’s a pain to find oil it worked but alot of upkeeping, so I am going to try your advise I bought 182m (600ft) of (25.4mm) 1″ black poly pipe to start with, I have a spare pump to use, but I am a little worried that the pump is going to push the water to fast through the pipe unless I put a ball valve and choke it off, but when I do that I may damage the pump. you mentioned that a larger pipe would work better, any suggestions.
Hi. I get an …
Hi. I get an increase of ten degrees celcius with a flow rate of ten litres per minute. The black tube walls are fairly thin. I don’t know where you live, but here in Australia the poly piping is in every gardening shop and in fact we have dedicated shops just for reticulation. Good luck with you plans
jorgerojo73 …The …
jorgerojo73 …The plastic piping is polypropylene piping used for gardening. I used 19mm and I think 16mm would work fine. You would need to make sure that your pump wouldactually get the flow through 16mm or buy a dedicated pump for this … you can find them on ebay fairly cheap. It is amazing how much piping I used in the roll that you see in the video. Try buying four or five hundred meters to start and see how that goes.
Wich temperature …
Wich temperature you reach with this panel?
How thick are the black tubes walls?
Thank you a lot …
Thank you a lot Anthony for this video, could you help to advice me to build one? What kind of plastic is it? does a 16mm do it? how many meters did you use on the panel you show? once again, thank you a lot .